Camcorp HVP Specifications download pdf (Page 12)

CAMCORP, INC.

Phone: 913-831-0740 Fax: 913-831-9271

SETTING UP YOUR UNIT

CAMCORP dust collectors are shipped in various states of assembly depending on the

size and configuration of the unit. Before attempting to move the dust collector or any of

its sections, review both the certified general assembly drawing supplied with your unit

and the rigging and lifting guidelines included in this manual. Become familiar with the

size and number of sections to be assembled, the orientation of inlet(s), outlet(s), access

door(s), and fan as well as the number and location of lifting lugs.

Dust collectors of this type are manufactured from steel sheets and are quite flexible.

Therefore, even though care has been taken to maintain dimensional accuracy and

squareness, some difficulty should be anticipated, and temporary bracing in the field may

be required.

Rigging and Lifting Guidelines

1. Do not lift the dust collector by any attachments other than the lifting lugs

provided.

2. Use all of the lifting lugs provided on the dust collector, or a section of the

dust collector, when making a lift.

3. If the lifting lugs are located below the roof line of the dust collector or

below the top of the section of the dust collector, a vertical pull must be made

to avoid crushing the top of the unit. Use spreader beams to accomplish this

vertical pull.

4. Attach tag lines at several locations to be able to control the unit when lifted

and to prevent spinning or swinging.

5. The dust collector should be lifted and lowered at a slow, uniform rate and

not allowed to bounce or joggle since this can cause excessive impact

stresses at the lift points.

Doors and Flanges

: Hold-downs on doors should only be hand tightened. Excessive

pressure can distort the door panel itself resulting in leakage. All bolts on flanges should

be tight. All holes in the dust collector must be plugged prior to start-up if not being

connected.

5-1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 74 75

No comments

Camcorp HVP Specifications Page 12